< Previous | Contents | Next >

16.3.1 Copy Track (Selective Content)


Long press a VT[..] pad to show up the Track menu (Track Pad Mode must be Sel/Menu).


image

To copy Track content, select the COPY tab, and then choose “Track (Selective Content)”.


image

In the following dialog, you can choose the content and destination for the copy process. (by default, the complete Track is selected)


“Show Content Details” shows up detailed controls to select/deselect particular parts of the Track.


image



Choose “Select Bars”, if you want to copy only a selection of bars, rather than the complete Pattern length.


image

Select the content you want to copy, or deselect the parts to be excluded from the process.


image



Now select the destination for the copy process.


image


For this example, we leave the destination at „.. to a Track VT.. of your choice” (which is the default).


Note:

You can also choose to copy your selection ..

.. to a Track VT.. of your choice (in a Pattern of your choice)

.. to the same Track in all Patterns in the Pattern Set

.. to the same Track in a selection of Patterns in the Pattern Set

.. to the same Track in all Patterns in a selection of Pattern Banks (A, B, C, D) in the Pattern Set Confirm with OK.

Since we’ve selected „.. to a Track VT.. of your choice” as destination, you’ll be prompted to select the destination Track.


image

Note: Depending on the selected destination, you’ll be prompted differently (e.g. to select multiple Patterns or Pattern Banks).



Finally, select the destination Track to copy the Track content to.


image

Note: The destination Track can be in the same or in any other Pattern, you can navigate to another Pattern in the Pattern Set, or you can even load another Pattern before you paste the copied content.


 Get this Doc as PDF