< Previous | Contents | Next >

5.2.5 Import G-Stomper Studio/Rhythm/VA-Beast Pattern as Scene‌

G-Stomper Producer can import Patterns created with G-Stomper Studio, G-Stomper Rhythm or G- Stomper VA-Beast (standalone). Such Patterns can either be imported as Scene or as new Project. In this example, we’re importing a G-Stomper Rhythm Pattern as Scene.

Show up the Main Menu.

Select the “Imp” tab and …

• short click “GSR Pattern as Scene”, if you’re on Android 8.0 or higher (the buttons won’t be long pressable on Android 8.0 or higher anyway).

• long press (press and hold) “GSR Pattern as Scene”, if you’re on Android 7.x or lower.

Once the “System Files Picker” shows up, press the “Menu” button (the three horizontal lines) in the upper left corner (or likewise swipe from left to right), and then select the pack from the menu.

Inside the G-Stomper Rhythm content, navigate to the “rhythmpatterns” folder or a subfolder where the Pattern is stored, and then select the one you want to load.

Note: On Android 8.0 or higher, the “System Files Picker” will directly show up in the correct folder. Unfortunately this was not supported on older Android versions.

Finally, select the Scene Slot to import the selected Pattern into.

Note:

Likewise, you can also import G-Stomper Rhythm (and other) Patterns as Scene using the Scene Slot Menu of a specific Scene Slot. Simply long press the Scene Slot to show up its menu, and then select the “Imp” tab and choose “GSR Pattern as Scene”. As a matter of course, selecting the destination Scene Slot is not required in this case.

< Previous | Contents | Next >

 Get this Doc as PDF