< Previous | Contents | Next >

5.6.3.2 Chain Trigger~Accent ON

Long press the Accent button to turn the ‘Chain Trigger~Accent’ mode ON/OFF.

The ‘Chain Trigger~Accent’ operation mode lets you control the Trigger and Accent steps by multiple clicks (without having to switch between Trigger and Accent).

In Normal mode (Accent disabled) + Chain Trigger~Accent ON: 1st click: Sets a regular trigger step (no Accentuation)

2nd click: Turns the trigger into an accentuated trigger

3rd click: Turns the step off

Note:

An accentuated step (e.g. 07, 09) is played at a higher (or lower) level than on non-accentuated steps (e.g. 05, 13). The actual level of an accentuated step depends on the Accent Amount (which goes from - 100 to +100). Accent Amount > 0 plays the sample louder, Accent Amount < 0 plays the sample less loud (also known as ghost notes) in relation to regular non-accentuated steps.

Accent + Chain Trigger~Accent ON:

If enabled, Trigger- and Accent steps are linked, in other words you’re always toggling an accentuated step ON/OFF with a single click.

< Previous | Contents | Next >

 Get this Doc as PDF