< Previous | Contents | Next >
Make sure that the sequencer is running (this is required to use the Stutter).
Make sure the R-Arp/Stutter switch is set to “STUT”.
Now, while the sequencer is running, simply touch/move the Stutter fader to turn the Stutter on.
As long as you hold the fader, the Stutter will stay enabled. When you release the fader, the Stutter will continue until the regular end of the currently running Bar and turns off afterwards.
Note: In the same way, the Stutter Effect can be used on the Sampler Drum Pads.
< Previous | Contents | Next >
Get this Doc as PDF
This Website or its third party tools use cookies, which are required by our content management system and our support forum for their proper and safe operation. By closing this banner, scrolling this page, clicking a link or continuing to browse otherwise, you agree to the use of cookies in accordance with our Privacy Policy.OkReview our Privacy Policy