< Previous | Contents | Next > Use the Stutter Effect

Make sure that the sequencer is running (this is required to use the Stutter).


Make sure the R-Arp/Stutter switch is set to “STUT”.


Now, while the sequencer is running, simply touch/move the R-Arp fader to turn the Stutter on.

As long as you hold the fader, the Stutter will stay enabled. When you release the fader, the Stutter will continue until the regular end of the currently running Bar and turns off afterwards.


Note: In the same way, the Stutter Effect can be used on the Sampler Drum Pads.

 Get this Doc as PDF