< Previous | Contents | Next >
In G-Stomper Studio, Patterns and Tracks are structured as followed:
This means, a Pattern holds all Tracks, T01-T24, VT01-VT12, and also FX, Master, and Timing & Measure. You can copy complete Patterns within a Pattern Set, or you can copy Track data either to another Track in the same Pattern or to other Patterns.
In detail, this means you can …
• … copy data from Patterns or Tracks to a wide range of destinations
- to single Patterns
- to single Tracks
- to all Patterns in a Set
- a selection of Patterns
- a complete Pattern Bank
• … swap data between Patterns or Tracks
• … clear data from Patterns or Tracks You can copy, swap or clear …
• … complete Patterns or selective content
• … complete Tracks or selective content
• … complete FX setup of selective content
• … complete Master/SumFX setup or selective content
• … complete Timing & Measure setup or selective content In Short, you can copy everything to everywhere at every time.