Delay-Artifacts on Volume off

[neolex]

If I define a delay insert effect in the mixer on some track (Drum Sampler or VA-Beast) in G-Stomper Studio and then turn the channel volume all the way down (but without muting or solo-off), some channel's sound artifacts will still pass through, unless the delay mix is ​​set to dry. This is obviously unfortunate because I don't mute the channels on my MIDI keyboard, but rather turn the volume off.

[planet-h]

Thanks for the report, Neolex.
Are you using only delays on these channels?
Or also other fx in addition?
The best would be if you could send me a pattern or pattern set with that problem by mail.

[neolex]

Hi planet-h,
sorry, I haven't seen your reply.
In some patterns I also use an Equalizer in addition, but in others not. It also happened with only the FX INS on a channel.
To what email address shall I send the pattern?
Best regards

[neolex]

Now I have found gstomper(at)planet-h(dot)com. I will mail you a pattern...

[neolex]

I sent an example pattern by email, but I'm not sure now, if the volume of T04 in that example is all the way down (off). I left the volume a bit open, because the artifact that way doesn't appear. But on sequencer stop it appears anyway.

[planet-h]

Hi neolex

I sent an example pattern by email, but I'm not sure now, if the volume of T04 in that example is all the way down (off). I left the volume a bit open, because the artifact that way doesn't appear. But on sequencer stop it appears anyway.

Great, thanks a lot for sending an example. I got your mail.
Will check it later today.