PLANET-H.COM

Hi there, longtime G-Stomper User here, thanks alot to you Guys.
Trying to assign my Arturia Beatstep Pro - Controler Mode Knobs to my G-Stomper Studio Synth Tracks.
The assigning to the Global Channel Mappings, the FX1-3 Parameters to the Knobs worked out fine so far.
Now I have chosen different Channels to the Synthtracks VT01-6 to Midilearn their functions. This is where my problems begin, while I'm using the 'BA-Beast Synthesizer CC mappings' in the Setup. The goal is to assign different Knobs from the Beatstep to the Same function: the Filter1 Cutoff Frequency, to different VT. Although I have chosen different Channel Numbers to the VT, when I tried to learn the new Knobnumber for this particular function it just overrides the old number of the CC Knobs. So the new Knob I choose corresponds to the function I want yes, but also just to the newly chosen Track. Like the Midilearn to the Function can only be used by one Knob. So the question is: Is there even a way to control the same function of different VT over different Knobs and or the same Knob?
Thank you very much to all out there
And special thanks to the G-Stomper Crew for all the work.
Kind regards
Vincent

Thanks for your message.
Yes.
The different knobs must send the same cc number, just on a different midi channel. That should work.

That way you have to learn the cc only once.
And the channel defines which vt is targeted.