< Previous | Contents

11.3.4 Out


image

The Out section is used to adjust the Out Volume of the signal after it passed the EQ (50%..200%).


If you need to lower or raise the output volume depends on the audio signal as well as the EQ settings.


If the EQ settings result in a louder signal (e.g. if you boost the bass with the low band), then it makes sense to lower the output volume.


If the EQ settings result in a less loud signal (e.g. when you lower the bass with the low band), then it makes sense to raise the output volume.


Use the VU Meter at the right side to monitor the EQ Output signal.


In some situations it’s helpful to have a quick A/B comparison (with and without EQ).

Just use the ‘Bypass EQ’ to completely bypass the EQ.



 Get this Doc as PDF